Cable Detection Ezitex t100 Signal Generator Product Information
Dual Frequency Signal Generator. Designed in conjunction with the EZiCAT locators, to easily and accurately trace the route of, or locate, an underground cable or metal pipe that does not carry a naturally present signal. The Ezitex t100 generates a specific "active" signal, which can then be traced using the EZiCAT. Enclosed in a high impact structural polypropylene case, the EZiTRACE is a tough piece of equipment built to last on the rough construction environment.
Cable Detection EZiTEX Signal Generator Technical Specification:
Choice of frequencies (8 kHz or 33kHz) for maximum site flexibility
Induction and connection output modes
Supplied with crocodile connection cable and earth spike
Variable signal output level for precise service location
Battery and output level indicators
Simple and intuitive button layout, perfect for inexperienced users
Automatic mode selection (connection/induction)
Rugged sealed case, perfect for the tough construction environment
Network Rail approved (PADS No: 094/020052)
Using the EZiTEX t100
Connect the EZiTEX t100 to a conductive service such as a valve, junction box or other access point.
Signal Clamp Connection
A Signal Clamp is used to apply the EZiTEX t100 signal to an insulated electricity cable. Supply is not interrupted by the signal and the operator is not exposed to any live services, such as a valve, junction box or other access point.
The EZiTEX t100 induces a tracing signal into the buried service. This is a quick and convenient method when direct connection or signal clamping is not possible.
Dual mode active tracing for on-site flexibility
Frequencies: 8 kHz & 33 kHz (Constant dual frequency available in connection mode)
Tracing range: Induction typically 150m, connection typically 250m
Dust and water protection to IP67 (with lid closed)